Raritan PCS12 Guida Utente Scaricare il pdf (Pagina 9)

Chapter 2: Pre-Deployment Planning

Basic Requirements for Dominion Products

All Dominion products include rack mounts for installation in standard 19

inch cabinets. Standard included power cables are for 110 VAC/15 amp

receptacles. Power supplies are 110/220 auto switching.

• Dominion KX devices use standard CAT 5 or better cabling for

connecting between the target and Dominion KX. The standard

supported distance is 150 feet. Each target requires a CIM.

• Dominion SX serial devices use standard CAT 5 or better cabling for

connecting to serial devices. Raritan DB9/DB25-RJ45 adapters need

to be connected to the device serial port for connection to the CAT 5

cable. Serial devices that use a RJ45 rollover interface should be

connected directly to the Dominion SX with a rollover cable. This

applies to most Cisco and Sun products. Use a 1 foot Raritan

rollover adapter cable to allow the use of standard CAT 5 or better

cabling for these type devices.

Prepare Network

Network preparation is essential for Raritan devices and CC-SG to

function properly over your LAN/WAN.

Allocate IP Addresses for Raritan Devices

IP addresses must be allocated and statically assigned for all Raritan

devices. To eliminate any possible address conflicts, first test any

allocated IP address to make sure it is not currently being used. See

Installation Template (on page 53) to document the IP addresses,

default gate

way, subnet m

ask, and administrative username and

password for each device. This information is needed during setup and

configuration.

Note: Dominion devices support 10/100 Ethernet. It is strongly

recommended that all Dominion KX devices be hard coded on both the

Dominion KX and Ethernet switch to eliminate auto negotiation problems.

Open Ports for Firewall or IP Port Filters

Raritan devices are accessed from a standard web browser. If a firewall

or IP port filter is enabled between the user PC, CC-SG, and Raritan

devices, ports must be opened to allow connectivity. See CC-SG and

Network Configuration (on page 62).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 69 70

Nessun commento

Raritan PCS12 Guida Utente Pagina 9