Raritan PCS12 Guida Utente Scaricare il pdf (Pagina 29)

Chapter 3: Prepare Raritan Devices

7. At the Admin Port > prompt, type config and press Enter.

8. At the Config > prompt, type network and press Enter.

9. To view the current interface settings, at the Interface > prompt, type

interface and press Enter.

10. To configure new network settings, at the Network prompt, type

interface followed by one of the following commands and its

appropriate argument (option), then press Enter.

Command Argument Options

ipauto none|dhcp none - Enables you to manually specify an IP address for the device. You must

follow this option with the ip command and the IP address, as shown in the

following example:

interface ipauto none ip 192.168.50.12

dhcp - Automatically assign an IP address to the device on startup.

ip IP address The IP address to assign to the device. To manually set an IP address for the

first time, this command must be used with the ipauto command and the none

option. See ipauto for information. After you have manually assigned an IP

address once, you can use the ip command alone to change the IP address.

mask subnetmask The subnet mask IP address.

gw IP address The gateway IP address

mode mode The Ethernet mode. You have the following choices:

 auto - Automatically sets speed and interface mode based on the network.

 10hdx - 10 Mbs, half duplex.

 10fdx - 10 Mbs, full duplex

 100hdx - 100 Mbs, half duplex

 100fdx - 100 Mbs, full duplex

When you have successfully changed a setting, you see a

confirmation message like the following:

1. When you are finished configuring the Dominion KX II-101, type

logout at the command prompt and press Enter.

You are logged out of the command line interface.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 69 70

Nessun commento

Raritan PCS12 Guida Utente Pagina 29